AeroBeez.com

Building Tip of the Week: Pull/Pull Rudder Wire Set-up

Posted by aerobeez On October - 16 - 2014

Hey pilots, welcome back! This week we have a bonus installment of Pete’s Tip of the Week. As always, these tips are intended to help with all types of model building, even if you don’t own an Aerobeez plane or have yet to take the first step into becoming an RC pilot. We want to help you improve your model building, set-up, and eventually flying skills.

So without further ado, today’s tip will focus on: Pull/Pull Rudder Wire Set-up

Before installing your Pull/Pull rudder wires and servo, use a piece of blue tape to hold the rudder centered. This will help greatly with setting up the rudder wire lengths.

7

Then when you run the rudder pull/pull cables, use a long carbon rod or wood stick.  Curl the cable end a bit and tape the cable to the end of the stick.  Using a smaller diameter stick will allow you to bend and flex the stick make it much easier to reach the cable through the pull/pull slot at the rear of the fuselage.  Once the cable exits the slot, all you need to do is hold the cable or have someone help you hold the cable.  Pull the rod straight back and remove the tape.  Blue tape works best.  It is strong enough to hold the cable but breaks free easily when you pull back to remove the stick.

9

Thank you all for reading Pete’s Tip of the Week and check back for more each week!

Be sure to follow us on all of our social channels for updates on products and other tips and tricks.

Facebook

Twitter

Instagram

Now go enjoy your building and flying!

 

Your Hobby, Our Passion!

Aerobeez

Leave a Reply

Web Site: www.aerobeez.com
Email: support@aerobeez.com
Phone: 877-813-5337






Follow Me on Pinterest